The device has the "protection class IP20" and should be installed as protected as possible.
Necessary tools
You will need a power drill, a 6mm drill bit, and a Phillips screwdriver.
Relevant Device Information
Important note: The sticker on the back of the device has the necessary information printed on it, which is required for commissioning. Make a note of these or take a photo of the label before installing the device.
Explanation:
Art. No = HOMAG article number
Serial = The unique serial number of the device
Hostname = address where the device can be opened in the browser. This is made up of the homag-iot-MAC address of the device
Password = device-specific password to access the device interface
Important: This information is required for commissioning.
Connecting accessories
The power supply is plugged in at port X1.
The network cable is plugged in at LAN1.
The external button is plugged in at port X13.
Please close the unused connections with the plugs provided.
As soon as the power supply is connected to a socket, the computer starts.
The network cable is connected to the hall network or to a free LAN port on a HOMAG Group Internet router.
The external button can be positioned freely (cable length 25 m).
Where is which cable plugged in?
How to connect the individual components correctly!
Mounting the PC in the bracket
The computer is locked into the DIN rail. The tab to be able to unhook it from the DIN rail must point downwards.
The accessories can be plugged in before or after.
The computer must snap into the holder.
Wall mounting
Draw the holes.
Drill the holes with the 6 mm drill bit and then insert the dowels.
Screw in the screws with the Phillips recess – about 3 mm away from the wall.
Hook the bracket into the screws.
After installation, you can peel off the protective film of the HOMAG logo.
Mark drill holes.
Mounting on the machine
Mark the holes.
ATTENTION: Check beforehand that there are no components behind the sheet metal that could be damaged!
Screw the screws directly into the sheet metal – these are self-tapping.
Hook the bracket into the screws.
After installation, you can peel off the protective film of the HOMAG logo.
Mounting in the control cabinet/TSN junction box
ATTENTION: Electrically trained personnel necessary!
You can mount the computer inside the control cabinet on a DIN rail. The power supply is either through the supplied power supply or 24V DC from the machine.
15 mm of space should be kept free around the side of the computer.
Also possible: Installation in the control cabinet on a DIN rail.
Mounting without bracket
The computer can also be stored without a holder. The ventilation slots on the back must not be covered.