Color signals
In the HOMAG CUBE, an LED band has been integrated behind the HOMAG logo to indicate the current status of the HOMAG CUBE by means of different color signals.
logo: white // color signal: blue-static = connected and ready for operation
Your HOMAG CUBE is ready for operation.
HOMAG CUBE starts
logo: white // color signal: white comet tail = start process
The HOMAG CUBE starts. This process can take 1-2 minutes. Wait briefly. At the end, the CUBE should light up blue.
Action necessary
logo: white // color signal: blue-flashing = information available
The CUBE works normally. However, there is information (e.g. "Firmware update available", "New device found",...). You can see what information is present if you enter the address my.homag.cloud in the browser on your PC and select your CUBE under "Shopfloor".
Alternatively, you can also find the corresponding information via diagnostics via the Internet or diagnostics in the local network.
General errors
logo: white // color signal: yellow-flashing = HOMAG CUBE error
Error in the HOMAG CUBE. You can see what information is available by entering the address my.homag.cloud in the browser on your PC and selecting your CUBE under "Shopfloor".
Alternatively, you can also find the corresponding information via the diagnostics via the Internet or the diagnostics in the local network.
Onboarding at tapio not completed
logo: white // color signal: white-blue flashing = HOMAG CUBE set up
The HOMAG CUBE is connected to the Internet - however, it must still be registered at my.tapio.one. Add the HOMAG CUBE via your app (e.g. productionAssist, materialAssist...) AND restart the HOMAG CUBE. Then check whether the HOMAG CUBE is present in your machine list at tapio. Then restart the HOMAG CUBE once again.
Problems with the Internet
logo: off // color signal: white comet tail = network error
There seems to be a network problem with the HOMAG CUBE. Please restart the HOMAG CUBE.
logo: orange // color signal: white comet tail = check LAN cable
A connection from the HOMAG CUBE to the network via LAN cable is interrupted. Please check the LAN cable to your switch/router.
logo: yellow // color signal: white comet tail = no link
A connection from the HOMAG CUBE to the network via LAN cable is interrupted. Please check the LAN cable to your switch/router.
logo: purple // color signal: white comet tail = no IP address
Please check the IP settings of the HOMAG CUBE via the local diagnostics.
logo: white // color signal: white-flashing = no connection to the internet
The HOMAG CUBE cannot connect to the Internet. Please check whether the LAN plug is inserted in the correct socket and whether the network requirements are met.
logo: blue // color signal: white-flashing = network error (NTP not available)
The HOMAG CUBE does not have time synchronization. Please check the network status on the cloud diagnostics in the NTP management area.
Service states
logo: white // color signal: yellow-blue = active serviceRemote connection
The HOMAG CUBE has established a serviceRemote connection to the HOMAG remote service server. You can activate and deactivate this connection yourself using the button on the CUBE. This connection is switched off by default and can only be activated by you.
logo: white // color signal: light blue-blue = SSH service active
The HOMAG CUBE has an SSH connection enabled. This allows you to connect directly to the CUBE with a PC via command line. This connection is switched off by default and can be activated and deactivated by you via the button on the CUBE.