In the HOMAG , an LED strip has been integrated behind the HOMAG logo, which uses various color signals to indicate the current status of the HOMAG CUBE.
Logo: white // Color signal: blue-static = Connected and ready for use
Your HOMAG CUBE is ready for operation.
HOMAG CUBE launches
Logo: white // Color signal: white comet's tail = launch process
The HOMAG CUBE starts. This process can take 1-2 minutes. Wait a moment. In the end, the CUBE should glow blue.
Action necessary
Logo: white // Color signal: flashing blue = information available
The CUBE works normally. However, there is information available (e.g. "Firmware update available", "New device was found",...). You will see what information is available when you enter the address my.homag.cloud in your browser on your PC and select your CUBE under "Shop floor".
Alternatively, you can also find the relevant information via diagnostics via the Internet or diagnostics in the local network.
General errors
Logo: white // Colour signal: flashing yellow = HOMAG CUBE error
Error in the HOMAG CUBE. The information available will be shown to you if you enter the address my.homag.cloud in your browser on your PC and select your CUBE under "Shop floor".
Alternatively, you can also find the relevant information via diagnostics via the Internet or diagnostics in the local network.
Onboarding at tapio not completed
Logo: white // Colour signal: flashing white-blue = HOMAG CUBE Setup
The HOMAG CUBE is connected to the Internet – but it still has to be registered at my.tapio.one . Add the HOMAG CUBE via your app (e.g. productionAssist, materialAssist...) AND restart the HOMAG CUBE. Then check whether the HOMAG CUBE is available in your tapio machine list. Then restart the HOMAG CUBE again.
Problems with the Internet
Logo: not lit // Color signal: white comet's tail = network error
There seems to be a network problem with the HOMAG CUBE. Please restart the HOMAG CUBE.
Logo: orange // Color signal: white comet's tail = check LAN cable
A connection from the HOMAG CUBE to the network via LAN cable is interrupted. Please check the LAN cable to your switch/router.
Logo: yellow // Color signal: white comet's tail = no link
A connection from the HOMAG CUBE to the network via LAN cable is interrupted. Please check the LAN cable to your switch/router.
Logo: violet // Color signal: white comet's tail = no IP address
Please check the IP settings of the HOMAG CUBE via the local diagnostics.
Logo: white // Color signal: flashing white = No connection to the Internet
The HOMAG CUBE cannot connect to the Internet. Please check whether the LAN connector is plugged into the correct socket and whether the network requirements are met.
Logo: blue // Color signal: white-flashing = network error (NTP not available)
The HOMAG CUBE has no time synchronization. Please check the network status on the cloud diagnostics in the NTP management area.
Service Conditions
Logo: white // Colour signal: yellow-blue = Active serviceRemote connection
The HOMAG CUBE has established a serviceRemote connection to the HOMAG remote service server for service. You can activate and deactivate this connection yourself using the button on the CUBE. This connection is turned off by default and can only be activated by you.
Logo: white // Color signal: light blue-blue = SSH service active
The HOMAG CUBE has an SSH connection activated. This allows you to connect directly to the CUBE with a PC via command line. This connection is switched off by default and can be activated and deactivated by you via the button on the CUBE.