You can activate the TeleService connection serviceRemote via the button on the housing of the HOMAG or via the local diagnostics page.
Button on the housing:
1. Press the button briefly once.
The icon changes from blue to this state.
2. Press the button a second time.<br>
The icon will now appear in this state.
Attention: The second press of the button may result in a delayed feedback from the LEDs (approx. 15 seconds).
3. Press the button until a white running light starts on the icon. Then release the button.
4. If successful, the icon will glow green for a short time.
5. Wait 30 seconds, then the icon will change to this state.
6. Please check the internet connection or contact the service by phone (+49 7443 13 6000)
Diagnostic Page:
Open the local diagnostics page from your internet browser.
The address is structured according to the following scheme:
http:// <Hostname> - from firmware 0.129.7
http:// <Hostname>:45001 - older than firmware 0.129.7
Please replace the placeholder <hostname> with the hostname indicated on the CUBE label.Attention: Your computer must be connected to the same network as the HOMAG CUBE.
Log in with the password on the nameplate.
Switch to the "TeleService" page.
Press the "Start ISN TeleService" button and confirm the dialog.