Exchange of a HOMAG CUBE

The procedure for replacing a HOMAG is the same for materialAssist and productionAssist sorting. When replacing a HOMAG CUBE for productionAssist cutting, nesting or feedback, you can simply skip the steps for configuring the LED strips and storage locations.

Please follow the instructions below to replace your HOMAG CUBE. With "Confirm & Next" you save your changes and get to the next configuration step.

Step 1: Start the configuration

Open the configuration of the corresponding workstation via the gear icon. Then click "Confirm & Next" until you get to the configuration for the HOMAG CUBE.

Starten der Konfiguration — Starting the configuration

Navigation zur Konfiguration für den HOMAG CUBE — Navigation to the configuration for the HOMAG CUBE

Step 2: Adding the new HOMAG CUBE

The new HOMAG CUBE can be added by scanning the label on the back. This can be done using either a tablet or a connected Bluetooth scanner. Please note that this process may take a few minutes.

As soon as the new HOMAG CUBE has been successfully added, please select it in the overview.

It is important not to delete the old HOMAG CUBE for the following steps.

Neuen HOMAG CUBE hinzufügen — Add a new HOMAG CUBE

Das Hinzufügen eines HOMAG CUBE kann einige Minuten in Anspruch nehmen — Adding a HOMAG CUBE can take a few minutes

Auswahl des neuen HOMAG CUBE in der Übersicht — Selection of the new HOMAG CUBE at a glance

Step 3: Configuring the Printer

In the next step, select the printer that is assigned to the new HOMAG CUBE and confirm your selection.

Configuration of the printer is required before using it. First, select the label size (1) and then calibrate (2) the printer. The printout can be verified by issuing a test label (3 ). The alignment can be adjusted if necessary by adjusting the spacing (4).

Auswahl des Druckers — Selecting the Printer

Konfiguration des Druckers — Configuring the Printer

Step 4: Configuring the LED Strips

This is followed by the integration of the LED strips connected to your new HOMAG CUBE. These can be easily integrated by clicking on "Add LED bar".

Konfiguration der LED Leisten — Configuration of LED Strips

To set up a new LED bar correctly, apply the settings of the old bar that will replace it. Start by selecting the LED strip that goes with the corresponding LED box of the new HOMAG CUBE (1). If necessary, adjust the connection side (right or left) (2) and set the correct number of LEDs (3). Finally, save the settings via "Confirm".

Repeat the process until a corresponding new counterpart has been added for each old LED strip.

Konfiguration der LED Leisten vollständig — Full configuration of LED strips

Step 5: Configuration of the storage bins

To transfer the materials that are already stored in the existing materialAssist or productionAssist storage bins and to avoid data loss, simply adjust the existing storage locations by clicking on the pin in the row of the relevant workstation to start processing.

Übersicht Lagerplätze — Overview of storage locations

All you have to do is select the LED strip of your new HOMAG CUBE and confirm your settings.

Lagerplatz bearbeiten — Edit Storage Bin

Repeat this process for all bins. Once all of them are reconfigured, you can proceed to the final step.

Neue Lagerplatzkonfiguration — New Storage Bin Configuration

Step 6: Erase the old HOMAG CUBE and the old LED strips

In the last step, remove your old HOMAG CUBE and the associated LED strips. Navigate the configuration by clicking on "Back" until you reach the respective configuration step for "HOMAG CUBE" or "LED strips". Delete the devices by clicking on the garbage can icon in the corresponding line. Please note that the deletion process cannot be undone.

Documentation Index