Adjustment of the behavior when using Plus-parts
intelliDivide Nesting
Use of Plus-parts
Previous behavior: Plus-parts were placed only if this did not affect the offcut size.
Adjusted behavior: Plus-parts are used to fill up the entire board to avoid offcuts.
The behavior of intelliDivide Nesting when using Plus-parts has been adjusted.
Previously, Plus-parts were only placed if this had no influence on the offcut size. To simplify the workflow, Plus-parts are now used to fill the entire board. Offcuts and the associated handling effort are thus avoided.
Back to List
Stiles Machinery Inc. Sales
+1-616-698-7500 info@stilesmachinery.com www.stilesmachinery.comStiles Machinery Inc. Service
+1-616-698-6615 techsupp@stilesmachinery.com Contact form