Create the master data for edgebandings from the manufacturer Ostermann in materialAssist in a flash using a scan

materialAssist Edge

The creation of master data in materialAssist for edgebands from the manufacturer Ostermann has now become even easier, faster and more convenient. Click on Add coil(s) in materialAssist and then scan the existing barcode on your delivery bill from the manufacturer Ostermann.

If you have already created this edge band type in your subscription, you can now add the new coils directly.

If the scanned edge band type is not yet available in your subscription, the master data found in tapio will be displayed. You can check these, adjust them if necessary or simply confirm the data and then create your new coils as usual.

It's that easy!

Back to List