09/11/2023

Nesting plug-in: Manual nesting

Occasional nesting without separate nesting software.

Manual nesting of individual parts is now possible directly in the woodWOP interface.

The new Nesting plug-in makes it possible to manually nest individual parts directly in the woodWOP interface. With the new macro "Single Part", single parts are moved by touch or mouse. Minimum distances to the edge and to neighboring parts are monitored for rectangular workpieces. Optionally, an additional formatting macro can be used for StayDown or holding bars. A separate license is required for this.

The advantages at a glance:

• This function enables easy programming, especially when reproducing defective parts

• Occasional nesting can be done without separate nesting software